Micromatic.com > Bar & Beverage > Dispense Equipment > Beer Equipment > Keg Tapping Equipment > Beer Taps (Faucets) & Shanks > Beer Shanks > Elbow Shanks > Elbow Shank Assembly

Elbow Shank Assembly, Chrome

Product Images

Elbow Shank Assembly

Description

Highlights

  • Elbow soldered into shank to prevent internal leaks that are common in the older elbow, flare nut, and gland elbow shanks
  • View Elbow Shank Assembly 
Note: Barbed elbow will fit 3/16" or 1/4" I.D. vinyl tubing.
Important information regarding Prop. 65 for CA residents.

Specifications

TypeElbow Shank
Length1-7/8"
Bore I.D.3/16"
Thread7/8"-14 (5/8" BSP)
MaterialChrome plated brass shank & 304 stainless steel elbow
Customer Reviews

Average Rating:


Product Quality
Ease of Use
Cost-Benefit
Customer Service
Overall
Great product & Outstanding customer service
By Greg from Holly Springs, NC on Monday, December 6, 2010
2 out of 2 found this review helpful
I bought these fittings for a tower I am building. I had a very minor issue with one of the shanks. Tricia and Kristina from their customer service team solved my issue in a very quick, easy and professional manner. I will very definitively purchase from Micro Matic whenever I need more equipment for my draft beer systems.

Was this review helpful to you?




Product Quality
Ease of Use
Cost-Benefit
Customer Service
Overall
Unique shank, solved my 2 1/2" beer tower problem
By matt from San Jose, CA on Friday, January 15, 2010
5 out of 5 found this review helpful
I wanted to do a MacGyver add-on to my single tap Kenmore kegerator draft tower. I figured out a way to make a two inch extension to the top of the tower (with a little piece of hardware from the plumbing aisle at HomeDepot)-- then I just needed to find a shank/tap that would fit inside this tiny tower diameter. And this thing fit the bill perfectly. The finish and quality seem to be very good. I think I may replace the stock shank that came with the kegerator with one of these because the stock one is not an elbow and it is kind of a pain in the a&& to keep clean and/or change the hose, or adjust/tighten. At first I was a little concerned about the price-- but when you realize that it's a shank AND tail piece in one, it comes out just fine, perhaps less than what you would spend on the two pieces separately.

Was this review helpful to you?




Product Quality
Ease of Use
Cost-Benefit
Customer Service
Overall
Great Quality
By Eric from York, Pennsylvania on Wednesday, October 28, 2009
5 out of 5 found this review helpful
I ordered this because my old elbow shank started leaking at the compression fitting. The quality is very high for the price. It was much higher quality than the stock shank I replaced. The new design eliminates the compression fitting that caused a lot of problems for people. Now I only wish I ordered a shiny new faucet as well.

Was this review helpful to you?



Replacement Parts
ItemPart #DescriptionPriceAvail.Qty 
1 4328 Shank Snap Ring $1.82 In Stock
2 4330 Sleeve $1.82 In Stock
3 4332 Coupling Nut $3.78 In Stock
4 D6P3C Chrome Outside Flange $5.40 In Stock
5 D7P Inside Tower Flange - ABS $2.70 In Stock
6 S-22 Serrated Lock Washer $1.96 Low Stock
7 D8 Tower Shank Nut - 1" $2.16 In Stock
8 4329-3E Elbow Shank $19.91 In Stock
arrow_upward