Looking for some help

[beerguy09]

Good Morning All! New to the Forum here. Last night i was putting together my new BC1206-2 (2 Faucet Kegerator Kit) and accidentally pierced the top of of the refrigerator where the 2 faucet beer tower goes by using the wrong size screw. It's a tiny pierce and i am wondering what i could fill this hole with. I certainly hope i didn't ruin it. Any and all help would be greatly appreciated! Thank you!

[pvs6]

If you are not going to be using that screw hole I would just fill it with (Hotstuff) expending foam or some other brand. If you are using it get a shorter screw or grind down the screw so it doesn't contact the roof. Then a dab of silicone caulk over the puncture or J B weld putty, either will make an air tight waterproof seal.

[djc]

Just a suggestion - don't use expanding foam. Expanding foam is strong enough to move a door jamb. Use non expanding foam.

[beerguy09]

Thank you both I appreciate your help. I am going to try the silicone caulk as i have some at home.