Blend rate adjustment

[Bhaus]

I have a tm100 that is currently 25/75 setup for lagers, well i'm looking into get a tm200 for the main bar and using this for a deck application. question is, besides spending the 300-400 to have it refurbed and switched over to a 60/40 box it it possible to adjust the current blender??

[DCullender]

The basic answer is no. These blenders are not designed for field adjustments. The gas ratio detector needed to test and adjust these units costs more than sending back to McDantim for resets. How far are the two beer coolers and how many beers are you pouring? Why not run both locations from one source. Unless you are crazy busy, like 5 kegs and hour busy, the TM200 may handle the load.

[Bhaus]

the second walkin for the deck/patio is located on the other side of the building (over 250ft). i just assume it easier to have seperate blenders. i wasn't sure how the blender worked...geuss i will call mm