Good morning all,
been lurking and learning here for a while, but now I’m in need of some support in my own rite. I didn’t have much luck searching for an answer, so here I am posing it directly!
i have a customer that is requesting a new tap system install. They appear to have a chase running from their cooler out under the bar that has never been used, for whatever readon. (Established business, been around for years). So I ran a fish tape through it and sure enough it runs from the cooler to the bar.
Here are my questions.
it appears that be no bigger than 4-5 inches. As much as I could tell it also looks like it may have straight 90* elbows. Have to verify when we go back for a more formal discussion.
how much could this hamper pulling a line set through this setup, and how many lines do you figure could fit, if I can lines through there to begin with.
thanks in advance
been lurking and learning here for a while, but now I’m in need of some support in my own rite. I didn’t have much luck searching for an answer, so here I am posing it directly!
i have a customer that is requesting a new tap system install. They appear to have a chase running from their cooler out under the bar that has never been used, for whatever readon. (Established business, been around for years). So I ran a fish tape through it and sure enough it runs from the cooler to the bar.
Here are my questions.
it appears that be no bigger than 4-5 inches. As much as I could tell it also looks like it may have straight 90* elbows. Have to verify when we go back for a more formal discussion.
how much could this hamper pulling a line set through this setup, and how many lines do you figure could fit, if I can lines through there to begin with.
thanks in advance
Comment