Tweet
So I'm new to the keg game.. I had to replace my beerline for my edgestar double tap keg. Keg was working well and pouring before.. Now after it won't work.. PSI is at 0 and won't move.. Is it possible tank leaked out or is there another reason this could happen? Thank you
-
-
Do you have a single or dual gauge regulator and is this 0 psi on the primary or secondary gauge?Malt is the soul of beer... and yeast gives it life..
but the kiss of the hop is the vitality of that life!
My three favorite beers: The one I just had, the one I'm drinking now and the next one I'll have.
http://kegerator-social-network.micr...bygrouptherapy -
It has only one and the 0 is on the primary.. It use to go to about 10-12 PSI.. But now it won't.Comment
-
Sorry, primary wasn't the work I was looking for, but I think you understood my meaning. If you only have one gauge, it should be the regulated pressure, not tank pressure. Close the tank, remove the regulator and just crack the tank open to see if you have anything. If the tank shows empty, get a new one and test for leaks.Malt is the soul of beer... and yeast gives it life..
but the kiss of the hop is the vitality of that life!
My three favorite beers: The one I just had, the one I'm drinking now and the next one I'll have.
http://kegerator-social-network.micr...bygrouptherapyComment
Comment