You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 4 of 4
  1. 09-13-2006 06:39 AM #1
    tfritsch
    tfritsch is offline Junior Member
    Join Date
    Sep 2006
    Location
    , , .
    Posts
    1

    Default Can I fill CO2 tank mid-keg?

    I was wondering if it is OK to un-tap a keg and get the CO2 tank filled while there is still beer in the keg?

    I think that un-tapping the keg would keep the pressure inside the barrel until the CO2 tank is re-attached. I would think it would only be disconnected for about a day, but I don't know if this will affect the taste/quality of the beer. Are there any other considerations that I should be aware of?

    Thanks in advance,
    Ted
    Reply With Quote Reply With Quote  
  2. 09-13-2006 10:35 AM #2
    psychodad's Avatar
    psychodad
    psychodad is offline Super Moderator
    Join Date
    Feb 2006
    Location
    , , USA.
    Posts
    1,313

    Default

    I see this as a better alternative to running out of gas Friday evening where you won't be able to get it refilled until Monday.


    Reply With Quote Reply With Quote  
  3. 09-14-2006 08:13 PM #3
    edramshaw
    edramshaw is offline Super Moderator
    Join Date
    Feb 2006
    Location
    Concord, NH
    Posts
    710

    Default

    If you untap the kep BEFORE disconnecting the regulator than you will be fine. Turn off any valves on the gas system as well and it will keep the system closed off. Good luck.
    Reply With Quote Reply With Quote  
  4. 09-14-2006 08:54 PM #4
    Scott Zuhse
    Scott Zuhse is offline Administrator
    Join Date
    Mar 2005
    Posts
    2,312

    Default

    Simply place the coupler in the untapped position while getting your cylinder refilled. The valve in the keg will form a seal. Once a fresh gas supply is available, re tap keg.

    Scott Zuhse, Instructor Micro Matic Dispense Institute
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Similar Threads

  1. Paintball CO2 tank
    By gdashoff21 in forum Party Equipment @ Home
    Replies: 23
    Last Post: 03-13-2010, 04:53 AM
  2. Where to get CO2 tank filled?
    By brettatk in forum Trouble Shooting & Beer Quality @ Home
    Replies: 14
    Last Post: 12-03-2008, 01:58 PM
  3. Parts to run regulator away from CO2 tank "?"
    By DuffMan99 in forum System Components - Pressure Side
    Replies: 1
    Last Post: 02-25-2006, 07:26 PM
  4. CO2 regulator and tank with Mixed Gas?
    By mcgull in forum Kegerators & Kegerator Kits @ Home
    Replies: 5
    Last Post: 02-21-2006, 10:40 PM
  5. where to get c02 tank filled?
    By mindless in forum Kegerators & Kegerator Kits @ Home
    Replies: 6
    Last Post: 01-18-2006, 04:50 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.