Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 10-18-2007, 05:04 PM
Newbie Newbie is offline
Junior Member
  
Join Date: Oct 2007
Posts: 2
Default new guage reads zero
I think I followed all directions but my guage is reading zero. Its not an emergency because I am drinking beer out of the new kegerator that is perfectly fine. I have reattached, bled lines, everything I can think of. Is it possible new guage is just broke?

My wife warned me that I needed to stop saying, "This is so much easier than I thought it was going to be."
Reply With Quote
  #2 (permalink)  
Old 10-18-2007, 05:40 PM
sadavantiowner sadavantiowner is offline
Member
  
Join Date: Oct 2007
Posts: 27
Default
Have you tried to "tap" the gauge?? If you used any type of teflon tape on the threads it may have ended up across the bottom of the gauge. Otherwise...it's probably just bad.
Reply With Quote
  #3 (permalink)  
Old 10-18-2007, 05:52 PM
Newbie Newbie is offline
Junior Member
  
Join Date: Oct 2007
Posts: 2
Default
Yeah I tapped it. Had some experience with gauges and have a feeling its just bad.
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 10:50 AM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.