01-12-2007, 03:43 PM
|
|
Junior Member
|
|
Join Date: Sep 2006
Location: , , .
Posts: 4
|
|
Beer Tower
I have a POS AVANTI Keg cooler and I was wondering if anyone knew which beer towers will work with the AVANTI. I've heard that AVANTI has issues with a lot of beer towers. Any info anyone can give me would be greatly appreciated. Thanks.
|
01-12-2007, 04:49 PM
|
|
Super Moderator
|
|
Join Date: Feb 2006
Location: , , USA.
Posts: 756
|
|
I'm not sure about the Avanti tower, but I'd ***ume that the problem is simple the same as most other low end kegerators, the tower isn't cooled. A new tower likely isn't going to be much help.
Try looking at these blower systems and accessories: http://www.micromatic.com/draft-keg-...d-cid-130.html
|
01-14-2007, 12:07 PM
|
|
Senior Member
|
|
Join Date: Aug 2006
Location: , , .
Posts: 83
|
|
I have the same POS Avanti, which is actually working quite well now thanks to MicroMatic. I purchased a MM 2.5 inch Tower and it works great. You have to drill 4 holes, but pretty simple to install. It took maybe 30 minutes. You may want to go with the 3 inch instead, but with the problems I have had with the Avanti I figured that I would just keep the same sized tower as the original.
|
01-14-2007, 08:19 PM
|
|
Super Moderator
|
|
Join Date: Mar 2005
Posts: 1,652
|
|
Did you install a blower as well?
|
01-14-2007, 09:11 PM
|
|
Senior Member
|
|
Join Date: Aug 2006
Location: , , .
Posts: 83
|
|
Quote:
Originally Posted by Scott Zuhse
Did you install a blower as well?
|
No i didn't. I usually toss the first pour. After everything I have been through with this unit, it is a decent trade off. Pours great now, at 38 degrees almost 100% of the time. NO FOAM either!!!!!! I am actually thinking about getting a dual tower. If I do that I will get a 3 inch. Avanti at least made the thing big enough to fit two Logs.
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -7. The time now is 09:57 AM.
Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions.
While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information.
Micro Matic reserves the right to monitor, remove or edit content at its discretion.
|
|
|
Toll Free Orders:
1 (866) 291-5756
