You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3
  1. 11-01-2009 04:31 PM #1
    tat2fever
    tat2fever is offline Junior Member
    Join Date
    Sep 2009
    Posts
    2

    Default Question about PSI

    I recently went from a single faucet tower with a 1/2keg to a 2 faucet tower with 2 1/6 kegs. I am staying with Amberbock but the other is Shock Top. Should I set my PSI lower since the kegs are smaller, the same or higher since there are now 2 kegs? The inside temp of my kegerator is right around 38degrees. Any help or ideas would be greatly appreciated. Thanks
    Reply With Quote Reply With Quote  
  2. 11-01-2009 04:36 PM #2
    californiakulak
    californiakulak is offline Senior Member
    Join Date
    Apr 2009
    Location
    Fresno, California
    Posts
    85

    Default

    Smaller kegs require the same psi as larger ones.
    Reply With Quote Reply With Quote  
  3. 11-01-2009 04:38 PM #3
    tat2fever
    tat2fever is offline Junior Member
    Join Date
    Sep 2009
    Posts
    2

    Default

    Okay thanks.
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.