Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > @Home Beer Dispensing - Kegerator & Party Events (Residential) > Trouble Shooting & Beer Quality @ Home
Sank Key Malfunction/slow poor Help

LinkBack

Thread Tools

Display Modes

#1 (permalink)

06-13-2006, 02:52 PM

Teewaddy

Junior Member

Join Date: Jun 2006

Location: , , USA.

Posts: 3

Sank Key Malfunction/slow poor Help

I have a cooler with approx 100' of SS tubing that poors slow. The regulator on the CO2 tank does ice up when in use but does regulate air flow according to the pressure guage I have installed. I have adjusted the regulator from 12psi up to 30 psi and the same slow poor comes out of the faucet every time.

Any Suggustions on why the flow out of the knozzle doesnt increase when I increase the PSI on the regulator?

Any suggestions on how to get more beer out of the faucet rather than a current slow trickle of beer?

Could it be a bad faucet? too much SS Tubing. Bad Sank Key??(Which brings me to my next topic.

I think My sank Key went just went bad. I went to clean out my coils with a 5 gal cleaning tank which I fill to run water and solution through the coils. Nothing is being pumped out. No pressure is being built up in the cleaning tank. When I engage the Sank Key with out the cleaning tank, I do not hear any pressure. Should I? Could I have a defective Sank KEy all of a sudden. How can I check.

Frustrated and looking for Help,

Teewaddy

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sank Key Malfunction/slow poor Help	Teewaddy	Trouble Shooting & Beer Quality @ Home	10	07-02-2006 06:36 PM
slow CO2 leak	c2mack	System Components - Pressure Side	3	02-01-2006 07:17 PM
Very Slow and foamy	crsblusky	Trouble Shooting & Beer Quality @ Home	7	12-24-2005 07:06 PM
Slow beer	jacksonronin	Kegerators & Kegerator Kits @ Home	3	12-16-2005 06:02 PM
slow and foamy	mikeythethumb	Trouble Shooting & Beer Quality @ Home	21	12-05-2005 03:09 PM

All times are GMT -7. The time now is 08:59 AM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.