Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 06-08-2008, 11:49 AM
A-Dogg A-Dogg is offline
Member
  
Join Date: Jun 2008
Location: Irvine, CA
Posts: 6
Post Tower Insulation
Is it necessary to insulate the tower if I will be installing a cooling kit in a kegerator? Will there be a lot of condensation on the outside of the tower?
Reply With Quote
  #2 (permalink)  
Old 06-08-2008, 01:01 PM
BrewGuru BrewGuru is offline
Super Moderator
  
Join Date: May 2008
Posts: 173
Default
It is highly recommended to insulate the tower, this will help prevent condensation, and energy loss, especially if it's a metal tower. ABS Plastic towers are much better natural insulators by nature and do not necessarily need insulation. Most towers come with a sleeve of of foam insulation and a small circular piece for the top.
Reply With Quote
  #3 (permalink)  
Old 06-12-2008, 08:11 PM
may1966 may1966 is offline
Member
  
Join Date: Sep 2007
Posts: 34
Talking
Hey I know this sounds crazy but my tower was condensating and the top of my danby stayed wet so I used an old wool sock it works and dont look to bad if you take your time and get it on just right I used 2 and it turned out fine just remember its not rocket science
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 05:30 PM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.