Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 05-12-2008, 02:34 PM
sox0407 sox0407 is offline
Junior Member
  
Join Date: May 2008
Posts: 1
Default Washer between beer line and tap
I just realized that I went through an entire keg without a washer where the beer line connects to the keg tap. Obviously, after realizing the mistake, I have now put back the washer. But my question is, have I done any permanent damage to the beer line and/or the tailpiece at the end of the beer line?
Reply With Quote
  #2 (permalink)  
Old 05-12-2008, 05:01 PM
monkey710 monkey710 is offline
Senior Member
  
Join Date: Feb 2008
Posts: 140
Default
Shouldn't have. Main purpose is to prevent beer spillage.
Reply With Quote
  #3 (permalink)  
Old 05-16-2008, 12:26 AM
BigBadJohn BigBadJohn is offline
Senior Member
  
Join Date: Nov 2007
Location: Southern Illinois
Posts: 113
Send a message via AIM to BigBadJohn
Default
Quote:
Originally Posted by monkey710 View Post
Shouldn't have. Main purpose is to prevent beer spillage.
.

If you dont see any beer spilled in the fridge nothing bad happened. Afterall, the parts are made of steel. Not like it will get hurt
I accidentally forgot the gasket when cleaning my lines tonight and shot beer line cleaner all over myself
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 10:18 PM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.