Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 12-15-2007, 09:48 AM
bbdsevans bbdsevans is offline
Junior Member
  
Join Date: Dec 2007
Posts: 2
Default new haier kegerator problems
we just tapped our first keg of dogfishhead 60 minute ale and the beer is not flowing through the tubes and filling properly. The co2 pressure is set at 10-12 but the beer just trickles out of the tap. What could be the problem?
Reply With Quote
  #2 (permalink)  
Old 12-15-2007, 08:32 PM
celo626 celo626 is offline
Member
  
Join Date: Oct 2007
Posts: 15
Default
Hi Sevans,

Is this the first beer you've ever tapped with your system? If so, it sounds like you have something lose. I would untap, and make sure all your connections are tight before re-tapping. Did you flip the gas valve to the open position? Any kinks in your tubing? I assume you have the beermaster model that I do. I find that I get the right pressure out the faucet by adjusting the pressure upwards on the CO2 valve.
Reply With Quote
  #3 (permalink)  
Old 12-17-2007, 02:44 PM
bbdsevans bbdsevans is offline
Junior Member
  
Join Date: Dec 2007
Posts: 2
Default
Just wanted to let everyone know that the problem with the new haier kegerator is solved. Seems the tap that came with the system was bad. Replaced the tap with a micromatic tap and everything is fine.
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 01:10 PM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.