Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > @Home Beer Dispensing - Kegerator & Party Events (Residential) > Trouble Shooting & Beer Quality @ Home
Strange Pour Rate Issue

LinkBack

Thread Tools

Display Modes

#1 (permalink)

08-13-2007, 10:22 AM

Sematic

Junior Member

Join Date: Aug 2007

Posts: 1

Strange Pour Rate Issue

Hey Fellas,
So I've poured prolly about 40 kegs out of my kegerator that I built. It's a 3 tower setup in a 15.5 gallon converted freezer chest. So I decided to brew my own beer. Which was a cool experience. Instead of botteling it, I asked them to keg it for me. I got the keg back to my place and hooked it up just like always, but holly god Beer literally SHOOTS out of the tap like a rocket! My first reaction was of course to check the gas.... The regulation was the same as always and for kicks I unplugged the gas off the coupler and tried pouring again.... Same thing Beer literally shoots out of the tap even with no gas connected?! I'm about out of ideas, but I do have a hand pump with a bleeder valve... I could bleed off the pressure from the keg entirely. I'm wondering if because this came from a custom brewery that doesn't do a lot of kegs, perhaps they pumped the beer into the keg too pressurized?!

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

All times are GMT -7. The time now is 04:15 PM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.