You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2
  1. 08-06-2005 12:05 PM #1
    jopaul
    jopaul is offline Junior Member
    Join Date
    Aug 2005
    Location
    , , .
    Posts
    1

    Default Keg is leaking beer

    I just bought a Summit SB500 kegerator, and with my first 1/4 keg I am experiencing a beer leak. The leak is occuring at the point where the beer tube connects to the tap. My question is, do most beer tubes have use rubber washer that connects to the tap? Mine only came with a wingnut, but I thnk I am missing a piece that would prevent the leak.

    Any help would be appreciated. Thanks.
    Reply With Quote Reply With Quote  
  2. 08-10-2005 04:00 PM #2
    topgun3208
    topgun3208 is offline Senior Member
    Join Date
    Apr 2005
    Location
    maryland
    Posts
    424

    Default

    there is a washer that connects between the line and the tapper. I forgot to install mine when I got my unit and it will leak bad. Install one and u r ready for some ice cold suds.
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Similar Threads

  1. Leaking CO2?
    By dumbgirl in forum Trouble Shooting & Beer Quality @ Home
    Replies: 4
    Last Post: 06-26-2006, 07:08 PM
  2. Leaking connection above the coupler
    By Pharzuph1 in forum Kegerators & Kegerator Kits @ Home
    Replies: 2
    Last Post: 03-25-2006, 10:15 AM
  3. tap is leaking
    By SPF in forum Trouble Shooting & Beer Quality @ Home
    Replies: 2
    Last Post: 01-10-2006, 10:50 PM
  4. Leaking CO2
    By crboots in forum Trouble Shooting & Beer Quality @ Home
    Replies: 1
    Last Post: 10-20-2005, 02:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.