You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3

Thread: HELP!!

  1. 07-22-2005 04:05 AM #1
    chadcwilliams
    chadcwilliams is offline Junior Member
    Join Date
    Jul 2005
    Location
    , , USA.
    Posts
    2

    Default HELP!!

    I have a Haier system that has worked well with the 1/4 kegs for a few months. I cleaned the lines the other night and bought a 1/2 keg. When I hook everything up I can't get beer to flow at all. I have checked the CO2 tank (full), it's setting (12 PSI), the lines (can blow air through all), and the tap (CO2 line is flowing, air flows through the beer line, the ball is in place and not sticking). I changed out the keg with a fresh one, but still have issues with beer not flowing.

    The only two things left that I can think of are an issue with the regulator or the tap. Any ideas or thoughts??



    Thanks,
    Chad
    Reply With Quote Reply With Quote  
  2. 07-22-2005 03:08 PM #2
    chadcwilliams
    chadcwilliams is offline Junior Member
    Join Date
    Jul 2005
    Location
    , , USA.
    Posts
    2

    Default

    Well, I seem to have fixed it. I had a new tap express shipped today and after putting it on, beer flows. Any ideas why the old tap broke??

    Thanks,
    Chad
    Reply With Quote Reply With Quote  
  3. 08-01-2005 10:30 PM #3
    Scott Zuhse
    Scott Zuhse is offline Administrator
    Join Date
    Mar 2005
    Posts
    2,289

    Default

    Only issue that comes to mind would be the check ball retainer was possibly missing??? What brand of coupler was it and what brand did you repalce it with?

    Scott Zuhse, Instructor Micro Matic Dispense Institute
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.