Home Beer Retail Beer Commercial Closed Chemical Systems   
Results 1 to 3 of 3
  1. 05-11-2007, 10:22 AM #1
    Austye
    Austye is offline Junior Member
    Join Date
    May 2007
    Posts
    10

    Default What pressure setting for Dos Equis

    Just bought my first kegerator, a Haier. Picking up a 1/2 barrel Dos Equis today. Will try stabilize the temp to 38 degrees. My elevation is 807 ft. What should I use for the Straight Co2 pressure ?
    Reply With Quote Reply With Quote
  2. 05-20-2007, 06:08 PM #2
    joshman1204
    joshman1204 is offline Junior Member
    Join Date
    Apr 2007
    Posts
    13

    Default

    I have been running 15psi on my last 3 kegs of dos equis with no problems at all.
    Reply With Quote Reply With Quote
  3. 05-23-2007, 03:58 AM #3
    metprof
    metprof is offline New Member
    Join Date
    Apr 2007
    Location
    Foley, Alabama
    Posts
    1

    Default

    a quick question. I have a 2 spout keg...one with Sam Adams and the other is Miller Lite. I cannot seem to get the CO2 pressure correct for both. SA likes about 15PSI and the ML goes foamy. When I lower the CO2 to about 10PSI, the SA goes foamy and the miller is correct. Now what? I'm loosing a lot of beer pouring off the head, especially when the head is nearly a full glass. Temperature is 38 degrees inside the Sanyo kegerator and this temperature is measured with a digital in a glass of water.
    Last edited by metprof; 05-23-2007 at 06:16 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.