Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > @Home Beer Dispensing - Kegerator & Party Events (Residential) > Trouble Shooting & Beer Quality @ Home
Pressure stuck at 10 PSI

LinkBack

Thread Tools

Display Modes

#1 (permalink)

02-14-2007, 01:06 PM

tbarnecut

Junior Member

Join Date: Feb 2007

Posts: 1

Pressure stuck at 10 PSI

Set up my kegerator to serve Guinness for teh first time. Have all the required hardware and a 5# mix gas tank. Everything was was working fine until last week when I noticed the pressure had dropped to 15PSI and I couldn't screw the screw in on the regulator any more to increase the pressure. The next day it dropped to 10 PSI and has held there for the past week. I'm not even half way through the keg of Guinness yet and the gas tank was just filled for this keg. Could the regulator be bad? I know its probably showing the correct pressure b/c I can tell when I pour a pint that there's not near enough pressure. I just don't understand why the pressure droppped like that and how I can increase the pressure if the screw is all the way in. Any ideas?

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

All times are GMT -7. The time now is 10:03 AM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.