02-04-2007, 07:49 AM
|
|
Junior Member
|
|
Join Date: Feb 2007
Location: Mt. Prospect, IL
Posts: 2
|
|
Hiss coming from Regulator - PHOTO
OK....only 1 month old is my MicroMatic Premium Dual Regulator. All of a sudden last night I started to get a "hissing" sounds coming from the regulator. I noticed that if I put my finger over this hole it stopped. (SEE PHOTO ATTACHED)
I have been dispensing HomeBrew for over a month perfectly fine...why did this start all of a sudden last night? My usual routine is to carb for 48 hours @ 34F and 25PSI. Then I back off gas to 8PSI and dispense, this method has worked fantastic for me. Why all of a sudden is that hole on the regulator hissing CO2?
Cheers!
Mark A.
|
02-04-2007, 09:28 AM
|
|
Senior Member
|
|
Join Date: Jan 2006
Location: Plains,PA , USA.
Posts: 171
|
|
Hole in diaphragm, contact MM for replacement
|
02-04-2007, 10:02 AM
|
|
Junior Member
|
|
Join Date: Feb 2007
Location: Mt. Prospect, IL
Posts: 2
|
|
Thanks! Hey....any idea how I would have gotten a hole in the diaphragm? The regulator is only 1 month old.
Mark A.
|
02-04-2007, 10:53 AM
|
|
Senior Member
|
|
Join Date: Jan 2006
Location: Plains,PA , USA.
Posts: 171
|
|
any number of reasons, only a month old could be a manufacturers defect
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -7. The time now is 09:47 AM.
Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions.
While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information.
Micro Matic reserves the right to monitor, remove or edit content at its discretion.
|
|
|
Toll Free Orders:
1 (866) 291-5756
