Long trail kegs
i have an older bev air unit and just bought a sixtel of long trail. The keg, with the rubber bumpers did not fit upright in my kegerator. It is currently stored on an angle. I wanted to get a half keg of long trail but am now worried it won't fit. Anyone have similar experiences
I really hate to be nit-picky, but are you talking about the 1/4 keg? The Miller kegs have a rubber side that makes it difficult to fit in some units, if 1/6 can you post pictures maybe a member can identify. By what I have read, there are only 3 types of 1/2 kegs, all should fit in a BevAir.
So you are having trouble with the height? Not sure of the specifics of your kegerator, but I do know for a fact that one of my friends is running a sixth of Long Trail along with two other sixths in his Haier. The Haier is very tight for three kegs front to back and side to side, so the Long Trail cannot be too far off the standard or it wouldn't fit in his set up. He does have one keg using a low profile coupler, but I'm not sure which. Could be a low profile coupler would make it fit.
What I have: Haier two tap, 525 faucets, tower cooler, 10' lines
What's on tap: Harpoon The Long Thaw
The Summary: (4) Yuengling, (3) Yuengling Porter, (1) Yuengling Black & Tan, (5) Bud Light Lime, (1) Keegans Mother’s Milk, (5) Blue Moon, (3) Landshark, (1) Widmer Drifter, (1)Magic Hat #9, (1) Abita Turbodog, (3) Sierra Nevada Ruthless Rye (2) Harpoon Summer, (1) Sierra Nevada Pale Ale, (3) DFH 60, (1) DFH Festina Peche,(1) Two Roads Road 2 Ruin, (1) Stone IPA
I think djc is right. If the keg fits, but the rise from the coupler/beer line is causing you to need to tilt the keg, then a low profile coupler should resolve this for you.
Our beer, which commeth in barrels, hallowed be thy drink
Thy will be drunk, I will be drunk, at home as it is in the tavern
Home Brew IPA
@ Killian Boy, I bought a 1/6 keg. I dont think they make long trail in a 1/4. At least not one I can find in NJ.
@djc / cubby: you guys have the solution. I should have clarified. The keg will fit upright when not hooked up. Thanks
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions.
While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information.
Micro Matic reserves the right to monitor, remove or edit content at its discretion.