Home Beer Retail Beer Commercial Closed Chemical Systems
Results 1 to 3 of 3
  1. #1

    Default Vissani Beverage Cooler Thermostat/Fermentation Chiller

    After reading through the forums a bit, I know that Vissani really isnt the best brand out there, but I figured I would post my question anyway. I would like to use the cooler as a fermentation chiller.

    I just purchased a Visanni Beverage Cooler, Model # MCBC58DST. It has a digital readout of the temperature and a small PC like fan in the back of the unit. The temp. range goes from 35*-54*. My question is, would it be possible to make the range go higher in temps. I have read a lot about people wanting to get cooler temps out of the machine, but I really need it to go to about 70* if it is possible. I have pulled the digital temp. readout and looked for a thermostat adjustment screw but as far as I can tell the unit uses a digital thermometer.

    Visanni (a.k.a. Magic Chef) also makes a wine cooler that as far as I can tell is the exact same model as the beverage cooler, just with a temp. range of 42*-64*, so it seems that I should be able to get this to work.

    Once again, my ideal temp. range would go from 35ish* to about 70*. Any help would be greatly appreciated! Should I go the External thermostat route? Is there an easier way to mod the internal thermostat to make the temp. range larger?

    Thanks in advance!

  2. #2
    Join Date
    Oct 2011
    Washington State


    In my opinion, it is far better and easier to buy an external temperature controller, like a Johnson. All you have to do is run the temperature probe into the unit, plug the Vissani into the Johnson, and the Johnson nto the wall. Just set the stock temperature to the lowest setting and the Johnson will take over from there - easily managing the temperatures you mention.
    2nd hand Danby 645
    Johnson A419 digital temp. Ctrl.
    Dual faucet tower
    MicroMatic premium Dual Primary CO2 Regulator outside with two co2 lines going in
    Minn-Kota water temperature gauge
    Tower fan cooler from ebay
    One tap has a 5' beer line, the other is 10'

    1100' elevation

    2nd hand Vissani
    Johnson analog temp. ctrl.
    replaced tower with 3" tower from the Danby
    MicroMatic premium Primary CO2 Regulator
    Minn-Kota water temperature gauge
    Tower fan cooler from ebay
    5' beer line

  3. #3
    Join Date
    Feb 2011


    Why do you want it to go to 70?
    What I have: Haier two tap, 525 faucets, tower cooler, 10' lines

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.