Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > Bar, Pub & Restaurant Beer Dispensing (Commercial) > System Components - Pressure Side
Parts to run regulator away from CO2 tank "?"

LinkBack

Thread Tools

Display Modes

#1 (permalink)

02-24-2006, 01:04 PM

DuffMan99

Junior Member

Join Date: Feb 2006

Location: , , USA.

Posts: 3

Parts to run regulator away from CO2 tank "?"

Can someone tell me what parts will be needed to run a CO2 regulator a foot or so from the CO2 tank itself. Parts such as the hose and what size I will need.

Thanks
~jason

#2 (permalink)

02-25-2006, 07:26 PM

Scott Zuhse Scott Zuhse is offline

Super Moderator

Join Date: Mar 2005

Posts: 1,584

Check out this high pressure hose.

Scott Zuhse, Instructor Micro Matic Dispense Institute

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I need fob parts	Jeff Stanley	System Components - Beer Side	2	09-10-2006 08:59 AM
thermostat, beverage air parts	thebutcher	Kegerators & Kegerator Kits @ Home	2	05-02-2006 08:42 AM
CO2 regulator and tank with Mixed Gas?	mcgull	Kegerators & Kegerator Kits @ Home	5	02-21-2006 10:40 PM
parts-fan	eviltroybot	System Components - Beer Side	1	11-05-2005 09:09 PM
Building 3 keg system. Parts List	jackle	Kegerators & Kegerator Kits @ Home	0	10-25-2005 10:04 PM

All times are GMT -7. The time now is 05:39 AM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.