Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > Bar, Pub & Restaurant Beer Dispensing (Commercial) > System Components - Pressure Side
Need to shorten my regulator

LinkBack

Thread Tools

Display Modes

#1 (permalink)

05-19-2008, 07:31 AM

timmytes

Member

Join Date: Sep 2007

Posts: 16

Need to shorten my regulator

I have a dual guage regulator from micro-matic. It is in a true tdd-1 kegerator and I need to shorten the length of the reg by about 1/2 inch. Is it possible to buy a shorter stem which goes from the first regulator to the co2 tank?

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

All times are GMT -7. The time now is 07:38 AM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.