Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

Go Back   Keg Beer Dispensing Discussion Forum - Kegerator > Bar, Pub & Restaurant Beer Dispensing (Commercial) > System Components - Pressure Side
N/C02 Gas Line N/C02 Gas Line

Reply
 
LinkBack Thread Tools Search this Thread Display Modes
  #1 (permalink)  
Old 05-03-2008, 12:37 PM
TheSlavik TheSlavik is offline
Senior Member
  
Join Date: Apr 2008
Location: Edmonton, Alberta
Posts: 79
Default N/C02 Gas Line
Due to Guinness needing higher pri from the regulator, do I need a stronger gas line than the stock Danby Vinyl line?

If so, do I need a special braided line? This is pretty much what my Danby came with, and I need to know if it will hold that higher pressure (30psi)

http://www.micromatic.com/draft-keg-..._SNP-10x2.html
Reply With Quote
  #2 (permalink)  
Old 05-04-2008, 10:59 AM
TAPMAN TAPMAN is offline
Super Moderator
  
Join Date: Mar 2006
Location: York, PA. , USA.
Posts: 175
Default
The stock gas line that came with the Danby should be fine for the 35 lbs that you need for Guinness. If you were using a blender that needs at least 55 lbs to operate, then you would need braided hose. Tapman
Reply With Quote
  #3 (permalink)  
Old 05-04-2008, 04:21 PM
TheSlavik TheSlavik is offline
Senior Member
  
Join Date: Apr 2008
Location: Edmonton, Alberta
Posts: 79
Default
Awesome! Thanks for the info, now all I have left to do is order my Keg of Guinness!
Reply With Quote
Reply

« Previous Thread | Next Thread »

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 01:04 PM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.