You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3

Thread: Beer Gas??

  1. 03-27-2008 11:00 AM #1
    Heischman
    Heischman is offline Member
    Join Date
    Jul 2007
    Location
    Dawsonville GA
    Posts
    10

    Default Beer Gas??

    Hi every one,

    Well I keep Amber Bock on Tap at home and was woundering if I should switch from Co2 too Beer Gas? Any sugestings, I am not sure if Amber Bock would work with a denser head. What do you think.

    thanks
    _____________________________________________

    -HEISCHMAN-
    _____________________________________________
    It only takes one beer to get drunk, I just can not remember if it is number 12 or 13.
    Reply With Quote Reply With Quote  
  2. 03-27-2008 02:02 PM #2
    Scott Zuhse
    Scott Zuhse is offline Administrator
    Join Date
    Mar 2005
    Posts
    2,312

    Default

    Continue to use 100% CO2 for Amber Bock. If you utilize the pre-mixed cylinder gas your beer will end up flat.
    Scott Zuhse, Instructor Micro Matic Dispense Institute
    Reply With Quote Reply With Quote  
  3. 03-28-2008 05:43 AM #3
    Heischman
    Heischman is offline Member
    Join Date
    Jul 2007
    Location
    Dawsonville GA
    Posts
    10

    Default

    Cool thanks man, thats what I was thinking.
    _____________________________________________

    -HEISCHMAN-
    _____________________________________________
    It only takes one beer to get drunk, I just can not remember if it is number 12 or 13.
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.