You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2
  1. 11-20-2007 07:23 PM #1
    edramshaw
    edramshaw is offline Super Moderator
    Join Date
    Feb 2006
    Location
    Concord, NH
    Posts
    710

    Default Regulator for Blender

    What type of regulator would I use for the nitrogen tank that is feeding a blender? I used a standard series nitrogen regulator from Micromatic but the pressure release valve blew on it after I had left the account. I had it set at 55 psi. Is it a bad regulator? Am I using the wrong regulator? Any help would be appreciated.
    Ed
    Blue Line Draft Systems
    www.bluelinedraft.com
    Reply With Quote Reply With Quote  
  2. 11-21-2007 03:53 AM #2
    TAPMAN
    TAPMAN is offline Super Moderator
    Join Date
    Mar 2006
    Location
    York, PA. , USA.
    Posts
    250

    Default

    Ed, you should be using the high pressure primary regulators when using a blender.They blow off at 115-125psi instead of 55-65 psi. Tapman
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.