07-28-2005, 07:24 AM
|
|
Junior Member
|
|
Join Date: Jul 2005
Location: , , USA.
Posts: 2
|
|
Two kegs off of reg. with single output? Help!!
I bought the premium reg from micromatic and would like to know I can run two kegs from it, and would I have to use different gauges to monitor the pressure. I didn't know if the gauges were different from the single to dual output regs. I just wanted to know before I ordered the dual fitting and the extra shutoff. Thanks,
|
08-02-2005, 07:26 AM
|
|
Junior Member
|
|
Join Date: Jul 2005
Location: , , USA.
Posts: 2
|
|
Anybody?
|
08-02-2005, 12:21 PM
|
|
Member
|
|
Join Date: May 2005
Location: , , USA.
Posts: 55
|
|
I think you would need to get an air distribution switch like this:
http://www.micromatic.com/product.php?pid=751-017
I'm sure mmscott will chime in soon. I have a dual facuet tower but I go the dual regulator to start with.
|
08-20-2005, 07:23 PM
|
|
Junior Member
|
|
Join Date: Aug 2005
Location: , , USA.
Posts: 7
|
|
This may not be correct, but I do installs and would only use a Y off of the regulator or even a T if I needed an additional line after the air divider.
|
09-01-2005, 11:57 PM
|
|
Administrator
|
|
Join Date: Mar 2005
Posts: 2,110
|
|
Using a tee from one gas source would suffice as long as the products are carbonated the same. What products are you dispensing?
Scott Zuhse, Instructor Micro Matic Dispense Institute
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -7. The time now is 05:32 AM.
Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions.
While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information.
Micro Matic reserves the right to monitor, remove or edit content at its discretion.
|
|
|
Toll Free Orders:
1 (866) 291-5756
