You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2
  1. 02-28-2007 09:50 PM #1
    jelway
    jelway is offline Member
    Join Date
    Sep 2006
    Location
    , , .
    Posts
    5

    Default pressure problems

    I though that I read an equation on this web site that helped you determine the proper beer line size. It looked into factors like length and rise. I was able to find one equation but that was more complex then I remember this one being. Any thoughts????
    Reply With Quote Reply With Quote  
  2. 03-07-2007 12:40 PM #2
    Scott Zuhse
    Scott Zuhse is offline Administrator
    Join Date
    Mar 2005
    Posts
    2,295

    Default

    Not quite sure what your question is. Are you trying to determine the balancing for a direct draw system that uses 100% CO2 or are you using a higher gas blend pressure for a remote system? Please advise.
    Scott Zuhse, Instructor Micro Matic Dispense Institute
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.