Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 12-03-2006, 10:42 AM
Strych9 Strych9 is offline
Junior Member
  
Join Date: Dec 2006
Posts: 1
Default Determining restistance of this Shank ***embly
Hi there,

I am thinking of using these shank ***emblys offered by Micromatic for dispensing through a wall. The 24" metal nipples will go through an interior wall in my home direclty into a kegerator/freezer located in a garage where they will be connected by 3/16" tubing to the kegs.

I am wondering how many pounds of resistance I will need to calculate for my draft system for the shank located below?

http://www.micromatic.com/draft-keg-...id-SH599F.html

Thanks!!

Strych9
Reply With Quote
  #2 (permalink)  
Old 12-03-2006, 12:00 PM
happytappy happytappy is offline
Senior Member
  
Join Date: Apr 2006
Location: Mid Michigan , USA.
Posts: 79
Default
1/4' stainless OD has 1.20 lbs resistance per foot leaving you at 2.4 lbs. If it is 1/4 " ID it would be .50 lbs/ft.
__________________
Happy Tappy Draft Beer Services
Serving Mid-Michigan and beyond
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 06:48 PM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.