Home Beer Retail Beer Commercial Closed Chemical Systems   
Results 1 to 4 of 4
  1. 03-16-2011, 05:56 AM #1
    timothy420
    timothy420 is offline Junior Member
    Join Date
    Sep 2008
    Location
    Ohio
    Posts
    21

    Default Bottoms Up Dispense System

    Local ballpark recently installed this in a portable beer box. Wondering if any techs out there have dealt w this system, and what their thoughts are on it. Have to figure out a way to clean it as well, any comments or ideas are appreciated. Thanks!
    Reply With Quote Reply With Quote
  2. 03-16-2011, 10:27 AM #2
    Scott Zuhse
    Scott Zuhse is offline Administrator
    Join Date
    Mar 2005
    Posts
    2,621

    Default

    I have a call into Grinon and once precedures are confirmed, they will be posted.
    Scott Zuhse, Instructor [url="http://www.micromatic.com/draft-keg-beer-edu/dispense-institute-online-cid-1870.html"]Micro Matic Dispense Institute[/url]
    Reply With Quote Reply With Quote
  3. 04-24-2011, 08:52 AM #3
    DCullender
    DCullender is offline Super Moderator
    Join Date
    May 2005
    Location
    Richmond, VA
    Posts
    223

    Default

    I was watching the videos on the GrinOn web site. In the set up video they show holding a cup upside down over the fill valve. Believe this to be in the priming stage. Would believe that this would also work for cleaning. There is a "PRIME" button for each valve. Step sequence: Press PRIME button, tap keg, hold cup over nozzle, press START/STOP button, press START/STOP button to stop flow.

    This is also the routine that must be completed to clear the lines after keg change.
    Reply With Quote Reply With Quote
  4. 01-19-2013, 01:08 PM #4
    BottomsUp
    BottomsUp is offline New Member
    Join Date
    Jan 2013
    Location
    Indianapolis, IN
    Posts
    1

    Default

    I just joined this forum and saw your posting. If you are still looking for information on line cleaning or have any questions, please contact me. Cleaning the dispenser is as simple as unscrewing (done by hand) the nozzle that is on top of the dispenser, rinsing it with soapy water, and wiping down the surface of the unit. Other than that standard draft line cleaning is all that is required. Bottoms up!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.