Dispensing

[Eric]

Dear Mike or Scott,

Howdy. This is my first post and I noticed your names on the forum. I am opening a pub and will be using keg coolers behind the front of the bar. However, to maintain the "Irish pub" look, I want to dispense from a bar top mounted dispenser with a decorative wood front. I need to extend my dispenser from the top of the cooler where it's normally mounted to the top of the bar. Is there a standard method for doing this? I am thinkg PVC pipe extension to allow the cool air to keep the lines cool for the extra 1 or 2 feet I will likely need. Any help would be greatly appreciated. Thank you.

Cheers,

Eric

[topgun3208]

Cant help you on your installation, but good luck on the pub

[Scott Zuhse]

Try to use a keg box with dual towers, remove these towers and then acquire an Irish Coffin Box (scroll down to find after selecting link) that will span over each hole on top of the keg box. The use of flanges and PVC with insulation on outside is quite common to bridge short distances between the keg box and dispense tower. Use one hole on top of keg box for the two flex tubes to force cold air into box and the other hole for tubing as well as cold air return. Call our Customer Service team @ 866 327-4159 for exact equipment set up and specifications.

Scott Zuhse, Instructor Micro Matic Dispense Institute