+ Reply to Thread
Results 1 to 2 of 2

Thread: draft systems

  1. #1
    kynaston is offline Junior Member
    Join Date
    Apr 2005
    Location
    , , USA.
    Posts
    1

    Default draft systems

    What is the best system to install commercially with about 12-16 varieties of beer.I've heard a lot of good things about the Kilkenny beer system.Any opinions or websites would be appreciated!

  2. #2
    Scott Zuhse is online now Administrator
    Join Date
    Mar 2005
    Posts
    2,311

    Default

    Kilkenny is a manufacturer of chillers for milk, beer and cold rooms. This is only one component of a draught system. Not sure of what support , if any, you would receive if you had a problem done the road.

    If you are attempting to dispense these products remotely, check out the Micro Matic dispense systems. Not only will you have low pour cost, high resale due to quality dispensing. We can refer a Micro Matic installer to specify the right system for you.

    Scott Zuhse, Instructor Micro Matic Dispense Institute

Similar Threads

  1. ? for Draft line cleaners
    By wineglow in forum Trouble Shooting & Beer Quality
    Replies: 10
    Last Post: 02-18-2007, 11:32 AM
  2. Black Flakes in my draft beer
    By Habana in forum Trouble Shooting & Beer Quality @ Home
    Replies: 7
    Last Post: 11-02-2006, 10:58 AM
  3. Guinness Draft
    By Jibsea in forum System Components - Beer Side
    Replies: 4
    Last Post: 10-30-2006, 05:34 PM
  4. Draft Beer System (Seattle)
    By jzic in forum Suggestions & Miscellaneous Topics
    Replies: 0
    Last Post: 07-20-2006, 11:32 AM
  5. draft beer installer
    By mjcoughlin99 in forum Suggestions & Miscellaneous Topics
    Replies: 2
    Last Post: 10-17-2005, 11:01 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.