You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3
  1. 01-28-2009 12:58 PM #1
    happytappy
    happytappy is offline Senior Member
    Join Date
    Apr 2006
    Location
    Mid Michigan , USA.
    Posts
    119

    Default Kegs in series line cleaning

    I have a few accounts with kegs(2) hooked up in series. There are a few ways I have found to clean these with a recirculating pump. 1 involves removing 1 coupler and connecting the lines together which takes a bit longer to set up (one account has 10 sets of kegs in series). What are you guys doing with these set ups ?
    Happy Tappy Draft Beer Services
    Serving Mid-Michigan and beyond
    Reply With Quote Reply With Quote  
  2. 01-28-2009 05:15 PM #2
    edramshaw
    edramshaw is offline Super Moderator
    Join Date
    Feb 2006
    Location
    Concord, NH
    Posts
    710

    Default

    I use one of these on the second keg's coupler: http://www.micromatic.com/draft-keg-...d-2S2-005.html
    It allows everything to pass through and cleans the lines and inside of both couplers.
    Ed
    Blue Line Draft Systems
    www.bluelinedraft.com
    Reply With Quote Reply With Quote  
  3. 01-28-2009 06:15 PM #3
    happytappy
    happytappy is offline Senior Member
    Join Date
    Apr 2006
    Location
    Mid Michigan , USA.
    Posts
    119

    Default

    Thanks, I knew that was an option, I just wanted to see what , if anything else there was.
    Jim
    Happy Tappy Draft Beer Services
    Serving Mid-Michigan and beyond
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.