You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2
  1. 01-07-2009 10:16 AM #1
    timmytes
    timmytes is offline Member
    Join Date
    Sep 2007
    Posts
    22

    Default Elbow Shank Question

    ! year ago I ordered from Mico-m the 3" dual tap tower. I went to replace the beer lines today and saw that the shank going into the tower was just a straight one, unlike the ones that I see on their website for replacement. Does this really matter as far as beer dispensing, or should I replace them with the 90 degree bent types.
    Reply With Quote Reply With Quote  
  2. 01-08-2009 08:22 PM #2
    DCullender
    DCullender is offline Super Moderator
    Join Date
    May 2005
    Location
    Richmond, VA
    Posts
    137

    Default

    You should be fine as long as the line does not kink in the tower.

    Dennis
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.