You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2
  1. 11-09-2008 08:52 AM #1
    edramshaw
    edramshaw is offline Super Moderator
    Join Date
    Feb 2006
    Location
    Concord, NH
    Posts
    710

    Default Tower advice from techs

    I am hoping to draw off from some of your experience with regard to a tower dilemma. Here the deal:

    I've got an install with a metro tower which has the 1/4 hard stainless tubing instead of the vinyl. Directly underneath the tower there is a cooler so I need to make a 90 degree turn about 4" from the base of the tower, what do you guys do in the situation? I am thinking about using a bender to simply bend them all but am not sure if I will have trouble with the stainless or the fact that there will be 10 (8 product and 2 glycol) tubes all together. I've also heard I can cut there off but I wanted to see what your experiences were. Any advice would be great.
    Ed
    Blue Line Draft Systems
    www.bluelinedraft.com
    Reply With Quote Reply With Quote  
  2. 11-10-2008 02:01 PM #2
    Larry Tapper
    Larry Tapper is offline Senior Member
    Join Date
    Mar 2006
    Location
    , , USA.
    Posts
    144

    Default

    I have done this with a bender, but you have to be very careful not to kink them. it also makes them hard to get through the cut hole in the bar. Good luck.
    L. Tapper
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.