
03-27-2008, 02:58 PM
|
|
Junior Member
|
|
Join Date: Mar 2008
Posts: 2
|
|
Help To Install 12 LIne System
Hope I am in the correct forum.. I would like to know where I can obtain a Manual that would explain how to Install My Own 12 Line System. Is a Glycol System Better Easier or Harder or are both Systems just as good... Any help would be appreciated.
Thank You
|

03-27-2008, 03:03 PM
|
|
Super Moderator
|
|
Join Date: Mar 2005
Posts: 1,323
|
|
If you are not dispensing a direct draw system, utilize glycol. No manual exists other than ones that are provided to attendees of workshops such as the Dispense Institute at Micro Matic. You must attend in order to acquire this manual.
|

03-27-2008, 07:22 PM
|
|
Junior Member
|
|
Join Date: Mar 2008
Posts: 2
|
|
Help To Install 12 LIne System
I am quite interested learning how to do it, But I dont want to mess it up either. Are there Manuals for Direct Draw Systems that I could read up on.
Suppose I go with a Direct Draw System. Will this handle 12 Lines and is this very difficult,.Also our Cold Room is about 40 Feet from the Bar area. And would the beer be Satis******* .. Also I would need supplies /??
Any help would be appreciated.
Thanks a Lot
Patrick
|

03-28-2008, 02:56 AM
|
|
Super Moderator
|
|
Join Date: Mar 2006
Location: York, PA. , USA.
Posts: 182
|
|
Go with glycol. They used to say you could go up to 25 -30 ft with a cold air system. Through training and years of experience, anything past about 15-20 ft, go with glycol. Tapman
|

03-28-2008, 05:18 PM
|
|
Senior Member
|
|
Join Date: Jan 2006
Location: Plains,PA , USA.
Posts: 169
|
|
If your estimating a 40 ft. run from your walk-in box to the dispense tower and your asking about what type of system would best serve you, I believe your out of your league for installing the system yourself. Do yourself a favor and allow someone that installs these systems all the time, install your system. Start making money from the first glass, instead of several kegs down the line, after correcting your mistakes!
|

03-28-2008, 09:20 PM
|
|
Super Moderator
|
|
Join Date: Mar 2005
Posts: 1,323
|
|
|
| Thread Tools |
|
|
| Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
All times are GMT -7. The time now is 03:57 PM.
Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions.
While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information.
Micro Matic reserves the right to monitor, remove or edit content at its discretion.
|
|
|