You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 3 of 3
  1. 11-02-2007 06:47 PM #1
    Angus
    Angus is offline Junior Member
    Join Date
    Nov 2007
    Posts
    1

    Smile Looking for Brass (not PVD Brass) Tower

    Hello,
    I am having a hard time finding a tower that meets my unique requirements, which are:

    1. Real polished brass, not PVD Brass
    2. Glycol cooled
    3. 3" Column, 2 or more faucets.

    I have found a 3" column air-cooled polished brass "shotgun" tower (I would prefer a tower where the two faucets have an angle between them, not the shotgun, which is optimized for filling pitchers). However, it is air-cooled and not available for a glycol-cooled system.

    Why real brass instead of PVD brass, you wonder? Well, this is for a residential installation, and the goal is to have the local brass plating shop re-finish the tower to take on an "antiqued" look to match the faucets / fixtures that are going into the same bar. This refinishing process is easy with real brass, but I am told not possible with PVD.

    Any suggestions? I have been Googling all day with no luck. Micromatic, Perlick, etc. Thanks in advance for any ideas!!!!
    -angus
    Reply With Quote Reply With Quote  
  2. 11-03-2007 02:16 AM #2
    TAPMAN
    TAPMAN is offline Super Moderator
    Join Date
    Mar 2006
    Location
    York, PA. , USA.
    Posts
    250

    Default

    Try ''******''. It seems they have a few towers that are not PVD and are glycol ready. Tapman
    Reply With Quote Reply With Quote  
  3. 11-03-2007 02:21 AM #3
    TAPMAN
    TAPMAN is offline Super Moderator
    Join Date
    Mar 2006
    Location
    York, PA. , USA.
    Posts
    250

    Default

    I don't know why you could write Perlick, but not ******. It rhymes with danner, but starts with a "B"
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.