You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2
  1. 08-14-2005 08:35 AM #1
    probeverage
    probeverage is offline Junior Member
    Join Date
    Aug 2005
    Location
    , , USA.
    Posts
    1

    Default cobra tower install

    has anyone installed any ice coba towers??
    we install 2 side by side,with a glycol unit under the towers,looped in one tower and back into the other,first tower will ice up good,the 2nd tower will ice up but not as well as the first,thinking of a pump and motor for each tower,i am useing a half hores power unit just for the towers, is there a in and out on the glycol loop on the towers???
    Reply With Quote Reply With Quote  
  2. 08-19-2005 01:13 PM #2
    Scott Zuhse
    Scott Zuhse is offline Administrator
    Join Date
    Mar 2005
    Posts
    2,303

    Default

    What is the temperature of your glycol bath and does the loop go into one tower then come out and imediately go to the next tower?

    Scott Zuhse, Instructor Micro Matic Dispense Institute
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Similar Threads

  1. New Install
    By bsmith8643 in forum System Components - Beer Side
    Replies: 1
    Last Post: 07-02-2006, 05:11 PM
  2. New Install Question
    By Darren in forum System Components - Beer Side
    Replies: 3
    Last Post: 02-26-2006, 05:33 PM
  3. How does one install a blower?
    By fubarman in forum Kegerators & Kegerator Kits @ Home
    Replies: 9
    Last Post: 01-29-2006, 05:23 PM
  4. New Install Questions
    By G4titan in forum System Components - Beer Side
    Replies: 5
    Last Post: 01-23-2006, 02:11 AM
  5. Install Question
    By oaksmith in forum System Components - Beer Side
    Replies: 2
    Last Post: 11-15-2005, 07:35 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.