You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2
  1. 01-08-2008 05:48 PM #1
    psychodad's Avatar
    psychodad
    psychodad is offline Super Moderator
    Join Date
    Feb 2006
    Location
    , , USA.
    Posts
    1,311

    Default Beer Line Cleaner

    http://www.micromatic.com/draft-keg-...pid-CFP-1.html

    This is the beer line cleaner that I've been using for quite a while. I used to use BLC but prefer the Clean Flo and it has done a good job.

    Tonight I was cleaning a corny that had had some honey ale in it. The sediment at the bottom was being quite stubborn and as I was going to use the keg to push Clean Flo through the lines anyway, I decided to see what the Clean Flo would do to dissolve the sediment. I put in a half scoop and a quart of hot water and within a few seconds the bottom of the keg was shiny and clean. I'm going to try it on my carboy next batch I brew.
    Malt is the soul of beer... and yeast gives it life..
    but the kiss of the hop is the vitality of that life!

    My three favorite beers: The one I just had, the one I'm drinking now and the next one I'll have.

    http://kegerator-social-network.micr...bygrouptherapy
    Reply With Quote Reply With Quote  
  2. 01-09-2008 06:15 AM #2
    edramshaw
    edramshaw is offline Super Moderator
    Join Date
    Feb 2006
    Location
    Concord, NH
    Posts
    710

    Default

    I'm both a homebrewer and a draft tech and I too use some of the chemicals I use for line cleaning for brewing. Big difference, a lot of these chemicals are what breweries use for their stainless as well.
    Ed
    Blue Line Draft Systems
    www.bluelinedraft.com
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.