You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 2 of 2

Thread: Beer Shank

  1. 03-30-2008 02:22 PM #1
    Gnipgnop
    Gnipgnop is offline Junior Member
    Join Date
    Mar 2008
    Posts
    2

    Default Beer Shank

    I need a Beer Shank longer than 5-1/8" to go through the door of a 1940's model refrig. Any idea if there is such a monster? I may just have to have a piece of pipe threaded to screw onto the end of my existing shank.
    Reply With Quote Reply With Quote  
  2. 03-30-2008 03:27 PM #2
    THE ICEMAN's Avatar
    THE ICEMAN
    THE ICEMAN is offline Super Moderator
    Join Date
    Dec 2007
    Location
    Sun Devil Country
    Posts
    609

    Default

    Check this page out...

    http://www.micromatic.com/draft-keg-...s-cid-332.html
    My conversion >>>---->>> KILLER KEGERATOR


    "Without question, the greatest invention in the history of mankind is beer. Oh, I grant you that the wheel was also a fine invention, but the wheel does not go nearly as well with pizza."
    -Dave Barry-

    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.