If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
New at this and was wondering if anyone knew of a kit that can be used to clean kegarator/corny keg hook up These are 5 gal kegs with two hookups - one for CO2 and other for beer line
Thanks
I'll echo psychodad.
I fill a corny keg partway with a mix of hot water and PBW. (I actually make the "PBW" myself because PBW is just 70% sodium percarbonate and 30% sodium metasilicate.) I run that through the beer lines and out the faucet.
Then I hook up a keg with a solution of water and iodophor and run that through. I leave the iodophor solution in the lines until a new keg gets hooked up.
I don't regularly clean the CO2 line. However, I use Corny taps that attach to the hose with a flare nut, so that I can easily unscrew the tap and soak it in PBW, followed by iodophor, as needed.
Comment