You Are Here:  
Keg Draft Beer Learning Center
North America (change region)

lunkhead lunkhead is offline
Senior Member

Mini Statistics
Join Date
01-31-2007
Last Activity
Yesterday 10:15 AM
Avatar
lunkhead's Avatar
Recent Visitors
The last 10 visitor(s) to this page were:
  1.  bkbdrummer
  2.  californiakulak
  3.  Crucial_25
  4.  horne
  5.  Lake
  6.  patruog
  7.  rb78nj
  8.  rdcollns
  9.  Scott81603
  10.  tonyfishn
This page has had 847 visits
Tab Content
Visitor Messages
About Me

  1. lunkhead
    If I had found this forum before my danby purchase I would have bought a used freezer and converted it. I had paid $500 new for the danby, now +$90 for external temp controllers. At $399 it's tempting. The danby is energy efficient and quite and with external control and tower cooling, works great. Just do your home work and make the best choice for you
  2. Lake
    I have a question on what is best for me to do about buying a new kegerator. I presently have an old commercial type two tower Perlick, that is on its last leg have to do a lot of work just to keep it going. Called Sams they have kegerators for $399.00 I think they are Danby, am reasonably handy with tinkering. I will be able to use my old regulator and other stuff, as I will be taking it to the dump. What do you suggest I buy to get cold beer, even if I have to mod it?
    View Conversation
Showing Visitor Messages 1 to 2 of 2

About lunkhead

Basic Information

About lunkhead
Location
Willis, Mi
Interests
drinking beer, mustangs and rock & roll

Contact

This Page
http://www.micromatic.com/forum/us-en/members/lunkhead.html

Statistics

Total Posts
Total Posts
775
Posts Per Day
0.68
Visitor Messages
Total Messages
2
Most Recent Message
08-27-2009
General Information
Last Activity
Yesterday 10:15 AM
Join Date
01-31-2007
Referrals
1

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.