You Are Here:  
Keg Draft Beer Learning Center
North America (change region)

babyboomerboy babyboomerboy is offline
Member

Mini Statistics
Join Date
03-15-2008
Last Activity
01-06-2009 06:33 AM
Recent Visitors
The last 2 visitor(s) to this page were:
  1.  billy102386
  2.  Occurdyclicky
This page has had 219 visits
Tab Content
Visitor Messages
About Me

  1. billy102386
    hey, i was hoping you could give me a hint on where to drill the hole for the nestalgia kegerator. I have a 10lb nitrogen tank and it obviously doesnt fit inside, i know there is what looks like a hole on the inside, is this where you drilled?
    thanks for any info you can give,
    Billy
    View Conversation
Showing Visitor Messages 1 to 1 of 1

About babyboomerboy

Basic Information

Contact

This Page
http://www.micromatic.com/forum/us-en/members/babyboomerboy.html

Statistics

Total Posts
Total Posts
20
Posts Per Day
0.03
Visitor Messages
Total Messages
1
Most Recent Message
10-14-2008
General Information
Last Activity
01-06-2009 06:33 AM
Join Date
03-15-2008
Referrals
0

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.