Micromatic Dual Secondaries Question

[SailCO26]

I'm in the process of upgrading my 1x secondary to a 2x secondary, and changed the brand to Micromatic (Premium). These come from MM with the hi-pressure input on the R side of the R secondary and a plug on the p***thru of the L side of the L secondary. The labels on the back show all "HI" on the horizontal ports, and "LO" on the verticle ports.

My question is does it matter which side the hi-pressure comes in and the p***thru comes out? Based on where my secondaries are installed I'd like to have the input on the L side of the gauge pack and the p***thru (hi-pressure output) on the R side.

Any issues with this?

Thanks!
Jim

[SailCO26]

Ok, so either this was a really stoopit question, or nobody knew the answer!

I contacted Micromatic directly, they said "no problem". The only issues mentioned by the tech were that the input port and the plug were sealed with "locktite". I had no issues removing mine (did require a few grunts, tho!), and will tape putting back in.

FYI to anyone else wanting to do the same...

Jim

[mctripj]

yeah, there is no problem with switching which end the plug is on. or you could mount the regs upside down lol