Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > @Home Beer Dispensing - Kegerator & Party Events (Residential) > Kegerators & Kegerator Kits @ Home
Single Tower Conversion

LinkBack

Thread Tools

Search this Thread

Display Modes

#1 (permalink)

09-21-2006, 07:56 AM

yddraig

Member

Join Date: May 2006

Location: , , USA.

Posts: 15

Single Tower Conversion

Are there any kits available to convert a single tower to a double? Or a double tower with only one faucet?

Do not meddle in the affairs of dragons, for you are crunchy and good with Tabasco and home brew

#2 (permalink)

09-21-2006, 03:02 PM

psychodad

Moderator

Join Date: Feb 2006

Location: , , USA.

Posts: 654

http://www.micromatic.com/draft-keg-...s-cid-612.html

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
kegerator conversion need help	first_timer	Kegerators & Kegerator Kits @ Home	9	08-27-2006 09:28 AM
1/3 double pump or 1/2 single	John Rose Draft-Tech Inc.	System Components - Beer Side	4	03-28-2006 03:48 PM
Two kegs off of reg. with single output? Help!!	sigep0435	System Components - Pressure Side	4	09-01-2005 10:57 PM
sub zero conversion?	dooleydog	Kegerators & Kegerator Kits @ Home	0	04-28-2005 03:05 PM
where to get conversion kit	oldpaint2	Kegerators & Kegerator Kits @ Home	1	04-04-2005 09:14 AM

All times are GMT -7. The time now is 12:01 AM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.