Beer Forum

Search Forum Show Threads Show Posts Advanced Search

		Keg Beer Dispensing Discussion Forum - Kegerator > @Home Beer Dispensing - Kegerator & Party Events (Residential) > Kegerators & Kegerator Kits @ Home
remote draw

LinkBack

Thread Tools

Display Modes

#1 (permalink)

09-13-2006, 07:07 PM

jelway

Member

Join Date: Sep 2006

Location: , , .

Posts: 5

remote draw

I currently have a regular single tower store bought draft beer system. I've placed it under my step and have attempted to build a cooling sytem to allow me to place my taps approx six feet away. it follows the same general idea that micro matic advertises. I can only seem to drop the temp down to 55 degrees from 75. I have a remote temp. probe in the cooled area. I know that the unit may not be strong enough but it doesn't run all the time. I have a blower but the price to purchase the plumbing is a little to expensive for me. Any advise?????

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are On Pingbacks are On Refbacks are On

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
remote draw	jelway	System Components - Beer Side	1	02-10-2007 08:16 PM
Remote Tap location	lmonetti	Kegerators & Kegerator Kits @ Home	3	10-10-2006 01:11 PM
Remote System	Jonny	Kegerators & Kegerator Kits @ Home	3	08-31-2006 03:38 PM
Remote draw set up questions	Pain in a Dirty Glass	System Components - Beer Side	1	05-09-2005 07:51 PM
Remote draw set up questions	Pain in a Dirty Glass	System Components - Beer Side	0	05-09-2005 02:17 PM

All times are GMT -7. The time now is 07:40 AM.

Note:

Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.