You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 4 of 4
  1. 05-23-2005 07:58 AM #1
    Auld Og
    Auld Og is offline Member
    Join Date
    May 2005
    Location
    , , USA.
    Posts
    55

    Default 2 kegs off of one regulator

    If I'm running two 1/6 kegs off of the same regulator (dual output kind) do I need to adjust the pressure or will the regulator provide the same psi to each keg?
    Reply With Quote Reply With Quote  
  2. 05-23-2005 09:05 PM #2
    Scott Zuhse
    Scott Zuhse is offline Administrator
    Join Date
    Mar 2005
    Posts
    2,312

    Default

    Same PSIG to both kegs. To adjust flow, shorten or lengthen the 3/16th I.D. beer tubing.

    Scott Zuhse, Instructor Micro Matic Dispense Institute
    Reply With Quote Reply With Quote  
  3. 12-01-2006 11:59 AM #3
    zbender
    zbender is offline Junior Member
    Join Date
    Dec 2006
    Posts
    1

    Default beer hose length

    you mentioned that To adjust flow, shorten or lengthen the 3/16th I.D. beer tubing.

    what does that accomplish? what length should the beer tubing be?
    Reply With Quote Reply With Quote  
  4. 12-02-2006 07:42 AM #4
    ernestbud
    ernestbud is offline Senior Member
    Join Date
    Oct 2006
    Location
    Tulsa. Oklahoma
    Posts
    100

    Default

    start off with 5' on each line and then shorten each time you shorten the line it will incrase your flow
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.