Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 11-07-2009, 12:34 PM
PointPleasantNJBeerguy PointPleasantNJBeerguy is offline
Senior Member
  
Join Date: Aug 2008
Location: Point Pleasant,NJ
Posts: 93
Default Drain Conversion on Bev Air DD units
Looking for suggestions on bypassing the drain/condensate lines on the Beverage Air DD coolers that have the hose coming out the bottom of the front end that are meant to go to a drain.Only because there is no drains close by to tie into to dump that line.Only thing I can come up with would be putting a couple tees in the lines and adapting to a internal drain bottle, kinda like the setup on the BM23 units
Reply With Quote
  #2 (permalink)  
Old 11-07-2009, 01:49 PM
woody woody is offline
Member
  
Join Date: Jul 2009
Posts: 28
Default
This totally doesn't answer your question but.....

My Perlick used to drain a lot of water before I cleaned the door seal/gasket really well. Now it hardly drains any. It helps to never open the door either.
Reply With Quote
  #3 (permalink)  
Old 11-08-2009, 04:53 PM
gregariousness gregariousness is offline
Member
  
Join Date: Oct 2009
Posts: 15
Default
i have a dd68, and we just ran some line into a bucket that sits on the inside... seems to be working fine so far.
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 03:00 AM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2009, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.