Find Local System Installers     Find Local Beer Line Cleaner     Buy Beer Equipment

Beer Forum

Search Forum                       Advanced Search

  #1 (permalink)  
Old 07-21-2008, 10:11 AM
TJHeck TJHeck is offline
Member
  
Join Date: May 2008
Location: Atlanta, GA
Posts: 30
Default Disconnecting beer lines/couplers?
Is it bad to disconnect/reconnect the lines/couplers from a keg after it has been tapped and co2 added to it? I am installing a new countertop to my bar and I have to run the lines through the counter. Is this ok to do more than just once?
Reply With Quote
  #2 (permalink)  
Old 07-21-2008, 02:19 PM
tjchris3 tjchris3 is offline
Member
  
Join Date: Jul 2008
Location: Tucson Arizona
Posts: 14
Default
im pretty new to this but i dont see why it would be a problem because it dont let the carbination out of the keg unless you pull the bleeder in the coupler itself. just make sure you turn the gas off at the regulator.
Reply With Quote
  #3 (permalink)  
Old 07-21-2008, 02:47 PM
edramshaw edramshaw is offline
Super Moderator
  
Join Date: Feb 2006
Location: , , .
Posts: 519
Default
If your system is set up properly than this should be fine.
__________________
Ed
Blue Line Draft Systems
www.bluelinedraft.com
Reply With Quote
Reply

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



All times are GMT -7. The time now is 01:53 AM.

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.


Contact Us - MicroMatic.com - Archive - Privacy Statement - Top
Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2008, Jelsoft Enterprises Ltd.
Content Relevant URLs by vBSEO 3.0.0 RC6 © 2006, Crawlability, Inc.