You Are Here:  
Keg Draft Beer Learning Center
North America (change region)
+ Reply to Thread
Results 1 to 4 of 4

Thread: 2 beers temp ?

  1. 07-15-2008 08:06 PM #1
    tjchris3
    tjchris3 is offline Member
    Join Date
    Jul 2008
    Location
    Tucson Arizona
    Posts
    14

    Default 2 beers temp ?

    Can i have a keg of guinness and something else ( coors, blue moon) in the same chest freezer? I know the temps vary and was wondering if i can meet in the middle or run the guinness at 38*? i would hate to ruin some good tasting beer but want the best of both worlds! Thanks
    Reply With Quote Reply With Quote  
  2. 07-16-2008 02:22 AM #2
    TAPMAN
    TAPMAN is offline Super Moderator
    Join Date
    Mar 2006
    Location
    York, PA. , USA.
    Posts
    250

    Default

    Guinness reccomends 38-42 deg. Your Guinness will be fine, but make sure you use the right gas mix (75%Nitrogen, 25% CO2)for the Guinness, and 100% CO2 for the other beer.
    Reply With Quote Reply With Quote  
  3. 07-16-2008 03:32 PM #3
    tjchris3
    tjchris3 is offline Member
    Join Date
    Jul 2008
    Location
    Tucson Arizona
    Posts
    14

    Default

    I knew about the gas, was just double checkin the temp. Thank you!!
    Reply With Quote Reply With Quote  
  4. 07-17-2008 02:33 PM #4
    Sammy1759
    Sammy1759 is offline Senior Member
    Join Date
    Oct 2007
    Location
    Hammond Ind
    Posts
    119

    Default tapman is the best

    TAPMAN I had that exact same question about temp and I did not know the answer, but thanks to you, now I do. Thank you As far as the mix gas 75/25 is there any other beer that uses it besides guinness?
    Reply With Quote Reply With Quote  
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Note:
Micro Matic’s Draft Beer Discussion forum is a public service which allows our members to share their draft beer knowledge and for visitors to view their discussions. While Micro Matic's Dispense Institute instructors and knowledgeable staff are often participates in the forum, Micro Matic does not attempt to verify information posted by members. The information which members post are personal views, and may not reflect the views of Micro Matic. Micro Matic takes no responsibility and assumes no liability for any information posted by members, or results that occur from the information. Micro Matic reserves the right to monitor, remove or edit content at its discretion.